Bob's Knobs for Telrad Finder # Telrad
Brand | Bob's Knobs |
Part Number | Telrad |
Availability | available |
Share |
Product Info
Manufacturer Description
Collimate your Telrad reflex finder without tools!
It's easy...just grab a Bob's Knob collimation thumbscrew and turn. Much easier to use with gloves on. And perhaps most importantly, you'll never drop that pesky little Allen wrench or screwdriver into the grass again. Installation is a snap with the included instructions, and you can undo the modification at any time.
Part: Telrad
Fits: Telrad Reflex Finder.
These stainless steel knobs replace the small plastic aiming knobs on the Telrad reflex finder.
Installation Instructions:
1. Tighten the three factory knobs by hand until they become slightly harder to turn. Do not force them.
2. Remove one factory knob and replace it with a Bob"ªs Knob. Repeat for the other two factory knobs, one at a time.
3. Loosen the new knobs two or three turns.
4. Mount the finder on your telescope and align.
Reviews
-
dvoprvb New Member
- Skill Level
- Unknown
- Time with Product
- Unknown
- User Notes:
- Review by Dvoprvb of CT.
Sep 27, 2013YES!
Pros:Accurate,Strong Construction,Easy to Use
Cons: Comments:On dark cold nights it is a pain to adjust. However these are bigger than the standard. Easy to install.
Bottom Line: Would you recommend this item? YesThis review was provided courtesy of AgenaAstro.com
Sort bySpecifications
Manufacturer Bob's Knobs Additional Information baader-1-25-lrgbc-filter-set-2458473 Prism Type No Eyepiece Focal Length Ships by Next Business Day