Corrector Dust Cap for Celestron NexStar 8SE Telescope
Manufacturer part number: NXS-8DC
Mar 20, 2019
Does the jobPros: Cons: Comments:
Purchased this cap for an older model Celestron Ultima 8" SCT. Not a perfect fit. The little tabs on the telescope tube rim at the 12 and 6 o'clock positions don't quite grab the notches in the cap when you place the cap in place and rotate it clockwise slightly to lock it in place. You can pull the cap off with enough force, but it stays on well enough that it does the job intended. The cap is hard plastic and should be durable enough.
This review was provided courtesy of AgenaAstro.comSep 16, 2018
CAP for Mes de LS8Pros: Cons: Comments:
I could not find a front CAP for my Meade LS8 so I tried the Celestron one. It fits perfectly.
When tube is stored It barely fits against the fork base and hand control has tomado be stored un another place.
This review was provided courtesy of AgenaAstro.comJul 25, 2017
Are There Two Dust Caps for the NexStar4?Pros: Cons: Comments:
Just received a replacement dust cap for a used Celestron NexStar4 OTA which I found at a flea market. My service from Agena was very good, but I find that the cap is a little too small and won't stay on. I think a bit of rubber cement or some such to make the contact points on the cap a bit tacky is all that is needed, but it makes me wonder if Celestron made a slight change in the NexStar4 tube dimensions at some point.
This review was provided courtesy of AgenaAstro.comSort by